The hot end used on a Kingroon KP3S 3d printer has an 'interesting' design that unfortunately makes clogs very likely to happen.
In this video I'll show you why the clogs happen, how to remove a clog and also give you some tips that I have used to prevent them happening again.

KP3S Pro Slicer Profiles:
https://drive.google.com/drive/folder...

Affiliate links (If you purchase something after clicking any of the below links I may earn a small commission at no cost to you. This is a great way to support the channel)

Kingroon KP3S Pro: https://s.zbanx.com/r/RG1q9lv9NNdY
Discount Code: BF3P

Heatgun:
https://amzn.to/3IUneVc

Nozzle Spanner(wrench):
https://amzn.to/3XsFHMR

..............................................................................................................................................................

BUY ME A COFFEE
If you're enjoying my content, why not consider supporting the channel by buying me a coffee?
Even very small amounts are greatly appreciated and reinvested into bringing you better content.

https://www.buymeacoffee.com/rickyimpey

You can also use the YouTube 'Thanks' button above if you prefer.
...............................................................................................................................................................