50" RC Flying Wing Full Step by Step Build Instructions. Check bellow for Links to all the products used in this build.
Thank you so much for watching!
Propeller Wall Art: https://cults3d.com/en/3dmodel/art/p...
If you like videos like this, consider buying me a coffee, it really supports me: https://www.buymeacoffee.com/troymcmi...
https://www.tiktok.com/@troymcmillan_...
See what else I am working on: / troymcmillan_rc
#3DPrinted,#RCAirplane, #ItFlies
STL Files: https://www.3daeroventures.com/shop/i...
Landing Gear Upgrade: https://www.3daeroventures.com/shop/i...
Products Mentioned:
Twotrees Saphire Pro 3D Printer https://www.aliexpress.com/item/40000...
LWPLA: https://www.3daeroventures.com/shop/m...
CA Glue: https://amzn.to/2J8EvNW
CA Accelerator: https://amzn.to/3fpbycz
4S 4000mAh Battery: https://amzn.to/37fulV7
AR620 Receiver: https://amzn.to/3j4PbK4
DX6 Transmitter: https://amzn.to/3l6NFsD
3pin wire assortment: https://amzn.to/3l1xNYt
XT60 connector: https://amzn.to/3iyZWnf
2mm push rod ends: https://amzn.to/3nnjD4U
ZBend pliers: https://amzn.to/34mA0rt
Hobby Knife: https://amzn.to/3eYOYJq
#11 blades: https://amzn.to/3vTJZ2W
Hot knife: https://amzn.to/34AGOB1
Drill Bits: https://amzn.to/3nIJzrx
Build Mat: https://amzn.to/3vJmauw
Carbon Rods: https://www.readymaderc.com
*These are the settings I used for my Twotrees Sapphire Pro 3D Printer with PLA. These settings are not going to work with every printer, or every PLA. Printers have different length bodin tubes, and PLA’s have different melting points. These may not work exactly for you, but should give you a good base to start with if you have a similar size printer. Good luck!
Profile 3 Cura Settings:
Quality:
Layer Height – 0.25
Line Width – 0.3
Shell:
Wall Line Count – 1
Infill:
Infill Density – 5
Infill Pattern Gyroid
Material:
Printing Temperature – 215
Build Plate Temperature – 60
Flow – 100
Speed:
Print Speed – 100
Outer Wall Speed – 35
Inner Wall Speed – 35
Travel Speed – 80
Travel:
Enable Retraction – Checked
Retract at Layer Change Checked
Retraction Distance – 5
Retraction Speed – 25
Retraction Extra Prime Amount – 0.5
Combing Mode – all
Cooling:
Enable Print Cooling – Checked
Fan Speed – 50
Mesh Fixes:
Union Overlapping Volumes – Checked
Special Modes:
Surface Mode – Normal
Experimental:
Slicing Tolerance – Middle
Disclaimer: I am sponsored by some of the products I mention. However, all of my opinions are my own. Some of the above links are affiliate links, that does not effect the price you pay for a product, but I may receive a small commission if you make a purchase. This helps support my channel and allows me to continue to make videos like this. Thank you for your support!!