Support my work   / pawelspychalski  
Learn how to connect your GPS module to Betaflight and configure GPS Rescue for a safe return in case of a lost signal. In this tutorial, we'll walk you through the steps to install the GPS module, set up the UART port, and configure the Betaflight settings for GPS Rescue. By the end of this video, you'll have the confidence to fly your drone with the peace of mind that GPS Rescue has got you covered.

12 NEW things you should know about Betaflight    • 12 NEW things you should know about B...  

Steps:
1 Install GPS module to your drone
2 Connect GPS to a UART port on your flight controller
3 Configure the UART port for GPS use in Betaflight Configurator
4 Set up GPS Rescue in the Betaflight Configuration tab

Note: Before attempting to install and configure your GPS, please ensure that your drone is properly built and functioning. Also, be sure to consult the Betaflight manual and the GPS module's manual for specific instructions and troubleshooting tips.

Recommended GPS receivers
Matek M105883 http://bit.ly/3LuvXPB
Matek M8Q5883 https://bit.ly/3ZVtPEd
Beitian BN880 http://bit.ly/348jk3D
Beitian BN180 https://bit.ly/3wc70gY

0:00 Why GPS is useful
0:55 UBLOX 6M, M8, M9 and M10 modules
2:40 With or without magnetometer?
5:33 The best place on your FPV drone to install the GPS receiver
7:05 Flat or tilted?
7:52 GPS wiring
8:18 Betaflight setup
9:19 NMEA versus UBLOX – one of them is bad
10:32 Autobaud and Autoconfig
11:40 Set Home Point Once
12:35 Ground Assistance Type
13:01 OK, does it work?
14:46 The Betaflight Configurator GPS tab
15:34 Failsafe and GPS Rescue mode
17:27 GPS Rescue as a flight mode
17:50 GPS on your Betaflight OSD
18:14 Outro