I recently had a job come in where I needed to bend some 2mm sheet steel. Now I don't have a press brake that would do that so I went on the search for one.
This video is about the one I found on eBay, the Cyclops press brake.
I believe they are made in low volumes, but none the less the one I received seems very well made. It had a few issues in my mind and I point these out in the video. Take a look!

Some of the spec on the Press Brake that I bought from Ebay:

Made in Sheffield, England
Heavy duty construction 15mm beam/base, webbed based for extra rigidity
Adjustable V plates to allow for thicker material and adjusting the bend radius min width 10mm max approx 35mm
Heat treated C45/EN8 15mm x 60mm Multiple fingers, widths 150mm, 100mm, 75mm, 50mm & 25mm
Adjustable back stops, up to 75mm, fully removable to allow clear access
400mm max bend width Max thickness at 400mm, 4mm
Runs on linear bearings with spring return 25mm dia guide bars
Overall width 520mm weight 35kg
Some tools included

There are 2 other sizes available. The seller has a video on the Press that I have included below:
   • Press Brake attachment for hydraulic ...  

Link to my Sealey 20tone press:
https://www.sealey.co.uk/product/5637...