In this video I cover the design, construction, and use of a 3D printed precision solder paste stencil printer. Applying solder paste to circuit boards for modern miniaturized electronic components is a daunting task. The stencil must be precisely aligned and flat to the board. I found cheaply available stencil printers subpar, so I decided to make my own.

This stencil printer is based upon an XYZR precision stage which allows the PCB to adjust in three directions and rotate. The 3D printed frame lifts the stencil on and off the circuit board, allowing rapid solder paste application. Finally, an integrated vacuum motor pulls the stencil tight with the PCB ensuring consistent results.

I plan to put this printer to good use building my tile lights project which you can check out here:
   • LEDs, Microcontrollers, and Microphon...  

Chapters:
00:00 Introduction
01:35 Stencil Printer Description
06:14 Building the Prototype
15:14 Making a Stencil and Testing the Prototype
19:02 Building the Final Version
23:26 Closing Thoughts

You can find the 3D model for this here:
https://www.printables.com/model/8754...

Besides a couple of spools of 3D printer filament, you’ll probably need the following to make this:

Dirt Devil vacuum https://amzn.to/3ycafez
XYZ Stage https://amzn.to/4dy2RdA
Rotation Stage https://amzn.to/3wvUJcQ
Footswitch https://amzn.to/3UEtXXA
Ball bearings https://amzn.to/3UVFdR5
440 screws https://amzn.to/44EkioF
832 screws https://amzn.to/3wuy80h
M4 screws https://amzn.to/3UVFy6j
¼” x ½” shoulder bolts https://amzn.to/3JYrLFu
Gas struts https://amzn.to/4bwTgBR
Threaded inserts https://amzn.to/4byi1xK
Soldering iron tips for inserts https://amzn.to/3JXnnqi

As an Amazon Associate I earn from qualifying purchases.