Part 2 of taking the slack out of a Stewart trailer drawbar.
The pivots on the trailer are line bored out to 60mm. This is done by using a short boring bar coupled with a flexi drive to make up for the offset of not being able to get square on.
The drawbar itself is put onto the radial arm drill and reamed out to 60mm with a big reamer.
A new pin is made but with a grease hole down the middle so the middle pivot can actually be greased.
The tailgate ram is removed and new ball joints are installed.
The drawbar is then refitted with a well greased pin and the last job is to refit the tailgate ram.

Hope you enjoyed the video.
Thanks for watching