What do you do if you're trying to set your ZOffset but your printer's stop limit switch is turned on and you can't go below 0, which you'll need to be able to do in order to actually set the ZOffset. Unfortunately your printer is not connected to your WiFi and you can't send the GCode command to turn off the stop limit switch. In this video I show you an easy way to send GCode commands to your printer, even if it's a standalone and not connected to WiFi or to any software that allows you to send GCode commands to the printer.

00:00 Intro
02:35 Installing Notepad++
03:32 Installing Notepad++ GCode User Defined Language
05:19 Writing GCode in Notepad++
07:36 Running Notepad++ Created GCode on Printer
09:34 Concluding Remarks
10:30 Outro