This is a scratch build video we did for the Edge 540 Foam Profile plane. Brandon walks you through getting your plans printed out, transposed onto the foam board, and then assembling the aircraft. We then install the electronics. In the next video we will power it up and program the radio. We hav attached a link to the plans below and a list of the parts we used. Thanks for watching and as always post any questions in the comments blow and we will get back to you asap.

Our website
http://www.aglaerial.com

Facebook:
  / aglaerialvid.  .

Link to plans for the Edge 540 Profile plane built in this video
http://www.rcgroups.com/forums/showth...

These are the components we used to assemble this plane
3 sheets Dollar Tree foam board
1 9x4.7 slow fly APC prop
1 221210 1400kv 3s motor
1 30amp ESC
3 Corona 929MG servos
1 Futaba 4ch Rx
1 1300mah 3s lipo
4 control horns
linkage rods
Hot glue gun
Fiber reinforced tape