Welcome to Part 3 of the FPV tutorial. In this video we will look at setting up a model on the transmitter with no settings. Then we will connect the GPS and the DJI O3 Air Unit to the Speedybee flight controller and then turn them on within the Inav configurator. Also, we will connect the Spektrum 4651T receiver to the flight controller and set it up in Inav. Then bind it with the Spektrum transmitter. Finally, we will look at changing the channel range values for in the CLI. This is specific for receivers like Spektrum. I didn't show in this video but will talk about it in the following video that I set the servo BEC on the PDB board to 6V.

Scale FPV with head tracking using Motionsic BAG pan and tilt gimbal. DJI O3 Air Unit

Inav documentation for Spektrum Recievers:
https://github.com/iNavFlight/inav/bl...

INAV Fixed Wing Setup Guide:
https://github.com/iNavFlight/inav/bl...

Links for the hardware I use:

SpeedyBee F405 v3 Wing Flight Controller
https://www.speedybee.com/speedybeef...

BZGNSS BZ251 FPV GPS Module
https://a.co/d/bVUfrGr

DJI O3 Air Unit
https://a.co/d/aegiuU8

Spektrum 4651T Receiver
https://www.horizonhobby.com/product/...

SRXL2 Update Cable Needed to connect receiver to SpeedyBee FC
https://www.horizonhobby.com/product/...

Chapters:
00:00 Introduction
02:41 Create Model on Transmitter
04:05 Connecting Hardware
09:53 Configure GPS
15:47 Enable DJI Air Unit
17:10 Failsafe/RTH
19:25 Bind Spektrum Receiver
22:13 Spektrum CLI Range Commands
28:52 GPS Working Example
30:49 Summary

#fpv #rcplane #headtracking #inav