Description

#StarWars #Vader #Tutorial

A few months ago, I made a book nook featuring Vader in the hallway from Rogue One. I used an LED filament from a high voltage lightbulb to create the lit lightsaber effect. This is obviously quite dangerous so I waited until I had a safer, low voltage option to put out a tutorial for you all. Many of you asked, so here it is. Thanks for your patience! I hope you enjoy and go on to make little lightsabers to your heart’s content.

These lightsabers are at the 1:12 scale which will fit with Bandai figure kits and 6” Hasbro Black Series figures. If you have any questions, let me know in the comments and I’ll help how I can!

My other Vader Build:    • Vader BOOK NOOK | Rogue One Diorama  

Materials:
Bandai 1:12 Darth Vader https://amzn.to/2HCtnru
3V LED Filaments (130mm) https://bit.ly/37FhvQG
LED Tape https://amzn.to/3hKUU6A
Slotted Aluminum Sheet https://bit.ly/37FCD9E
Opaque Acrylic Sheet https://amzn.to/31ECiAe
Solder https://amzn.to/2Rnrj8K
Heat Shrink Tubing https://amzn.to/2ZxjpOB
Copper Wire https://amzn.to/3hKUNYI
Plastic Cement https://amzn.to/3aQ4xPx
Super Glue https://amzn.to/3hj9Pp7
Masking Tape https://amzn.to/3hlux6Z
.040 Styrene https://amzn.to/3dfQRyB
.020 Styrene https://amzn.to/349KlFl
Old Frame (Thrift Store Find)

Supplies:
Safety Glasses https://amzn.to/3aJ6a1A
Hand Drill/Pin Vice https://amzn.to/3gl0uMr
XActo Z Series https://amzn.to/3lpHGPW
Utility Knife https://amzn.to/3gizOM8
Ruler https://amzn.to/2QghRTO
Nippers https://amzn.to/2CRDx5O
Wire Cutters https://amzn.to/34pvb0u
Tweezers https://amzn.to/3iVlUkW
Paint Brushes https://amzn.to/2FquzgJ
Helping Hands https://amzn.to/3hmEZvV
Soldering Iron https://amzn.to/2YmXVTW

Paint:
Rust Olium Flat Black

Music:
Autumn Wind Dyalla
Nobody Home Dyalla
Le Freak Rage
Giant iPhone Rage

Disclaimer: Some of the actions seen in my videos could cause bodily harm. I am not responsible for anything you do while attempting to recreate what you see me do.

Amazon Affiliate links are used above.