After going over Japanese WWII aircraft tail codes, we'll take care of everything in tail...horizontal stab, elevators, rudder, servos, linkages...and finish with the tail wheel.

Episode 1 Unboxing:    • Unboxing of the Phoenix Model 20cc 68...  
Episode 2 Ailerons & Flaps:    • Install Ailerons, Flaps, and retracts...  
Episode 4 Cowling & Exhaust:    • Install the Cowling & Exhaust  Phoen...  
Episode 5 Flight & review:

"The tail unit was of allmetal construction except for the rudder and elevators, which were fabric covered. The tail fin formed an integral part with the rear fuselage, while the horizontal tail surfaces were attached just above the fuselage centerline.
Each elevator had a metal trim tab that could be controlled by the pilot, but the rudder trim tab could only be adjusted on the ground."
Jackson, Robert. "Technical Descriptions: Tail." Combat Legend Mitsubishi Zero, The Crowood Press Ltd, 2005, pp. 89.

Books:
D'Angina, James Mitsubishi A6M Zero (Air Vanguard) Paperback https://amzn.to/3b48LnJ
Jackson, Robert Mitsubishi Zero (Combat Legend) https://amzn.to/3iDEGjb

Tail Code References:
Tail Code Info (Reddit) https://bit.ly/3iEltOe
PEARL HARBOR raid Akagi's fighters https://bit.ly/3ag7VUk
November 1st, 1942 to February 15, 1944 https://bit.ly/2YrS2HJ

National Museum of the USAF https://bit.ly/3EEIqKv
Real A6M2 Zero @ the Museum https://bit.ly/2XSxvfJ
PH196 – Phoenix Model product page https://bit.ly/2XM2sSI
Tower Hobbies product page https://bit.ly/3CEmXj7

RCGroups Forum Thread https://bit.ly/3AFW4e8
Flying Giants Forum Thread https://bit.ly/3kUmHq7
Hobby Squawk Forum Thread https://bit.ly/2Y65Ya9
RC Universe Thread https://bit.ly/3F6Bd6k

Servos:
Hitec D645MW 32Bit, High Torque, Programmable, Metal Gear Servo https://bit.ly/3dd2eaS
RTL Fasteners https://bit.ly/djmoose25