This is part 2 of this build series on installing a stage 1 Predator 420 into a Kandi go kart. This should be an awesome off road buggy when its done. Be sure to subscribe and hit the bell so you can follow along with this build. Thanks for watching.

Watch the full build series here    • go kart  

Front tires https://amzn.to/30QebkB
Rear tires https://amzn.to/3xeqjI8
Fuel line https://amzn.to/3fTUlrR
Fuel petcock https://amzn.to/3fN1vho
Brake master cylinder https://amzn.to/3o86aNW
Throttle cable https://amzn.to/3fPuGAo
Brake fluid https://amzn.to/2VhJsH0
Drive Belt https://amzn.to/3swvVe1
Light Bar https://amzn.to/35T46CW
Front Wheels https://amzn.to/39Ixpcj
40 Series Torque Convertor https://amzn.to/392BWri had to switch springs on rear clutch
420 Chain https://amzn.to/332JDKh
Rear sprocket 54T https://www.gopowersports.com/sprocke...
420 crankcase gasket https://amzn.to/3nJ3dDg
3/8 tap for governor delete https://amzn.to/3lUtjmo
Cutting disc https://amzn.to/38ADwjZ
Grinding flap disc https://amzn.to/2UoAFm5
SUPER CHEAP GRINDER THAT WORKS https://amzn.to/2Iz17Hl

My camera setup https://amzn.to/2M3qrqp
Microphone https://amzn.to/2XQq19c

By using the affiliate links listed above for Amazon or Ebay, I may earn a small commission from your purchase at NO additional cost to you. Your support from using these links helps our channel so I can continue to bring you more content!