Free energy motor using magnetic cancellation. We got the idea for building this prototype from the internet. The original inventor claimed 4 to 1 ratio of power in to power out. We built this free energy prototype to test the concept of the operation. The rotor is offset in respect to the stator so that the air gap at the bottom is very close and at the top, it is further apart. Half of the magnets on the stator are facing north and the other half are facing south. The permanent magnets on the rotor are facing north and they are pushed up 180 degrees of the rotation by repulsion and then they are pulled back down 180 degrees of the rotation by attraction. Then, a pulse from a battery is used to energize a coil momentarily to cancel out the back magnetic force or to bend the magnetic field momentarily until the magnet on the rotor passes by. At this point, the power to the coil is turned off and for the rest of the 350 degree rotation, the work is being done by the interaction of the permanent magnets between the stator and the rotor alone. This is only a prototype of a free energy motor using magnetic cancellation. It is very promising, a pulse from a 3 volt DC battery is enough to allow the rotor to begin rotating. Only a single coil was used for this experiment but there was enough room to install a second coil on the other side of the rotor. There is also collapsing field energy coming back out of the coil, either to power a load or charge a battery.
Website: https://mindoftesla.com