00:00 Unpacking
02:40 Preparations
04:09 Temporarily removing Zukka accessory bracket
06:02 Sizing up installation of New display's bracket
07:00 Using tape to premark handlebar position for reinstall later
07:46 Removing original handlebar bracket and installing New handlebar bracket for display
14:35 Reinstalling the Zukka accessory bracket
15:57 Test fit of New display in New bracket and Pretest the display for operation(pass/fail)
21:25 PreProcedures for removing right grip with integrated turnsignal switch
22:39 Loosing setscrew on handlebar knob allowing the handlebar to pivot
25:00 Removal of right grip(sorry the camera was not positioned 100% to see)
29:19 Right grip removed and make note NOT to put stress on turnsignal wire
29:45 How to mark position of right brake lever assembly orientation and removal
32:12 Removal of original display/throttle assembly
34:15 Reinstall of right brake lever assembly (a mistake at this point)
36:19 Install of New throttle/speed assembly
37:35 Reinstall of right brake lever assembly
39:11 Reinstall of right grip with integrated turnsignal switch(much detail this time)
43:16 Screws(2) for New display
45:24 Notes on zip tie placement (suggestions)
46:56 Highlighting features of new display