Now you can run Aluminum and Chrome rims through your manual tire changer. No scratches and no torn beads. Perfect for those Harbor Freight Tire Changers.

Bearings 99502H (no clip) : http://amzn.to/2mTFFgB
No Mar Removal Ends: http://amzn.to/2mTIsWP
Plastic protection for install (better than milk jugs): https://amzn.to/2oYIORA
Tire LUBE is a MUST: http://amzn.to/2m8tSL7
Basic Manual Tire Changer Machine: https://amzn.to/2mLAiVu
Saw I used to cut the steel Evolution Evo 380: http://amzn.to/2lOGxBZ

4 foot 3/4 black gas pipe from the Home Depot/Lowes
5/8" bolt and nut for bearings

For the mounting end I used 3/16" steel 4"x4" angle iron cut to 2" wide. I cut the short end to around 1" and left the other at 4". You don't need angle iron and could just bend or cut/weld an angle piece together. 1/8" material is too thin and I would use 3/16" or 1/4" material. Bearings are 1/8" back from the face of the HDPE plastic. The plastic is around 1/4" thick so the bearings are around 3/8" from the inside of the angle iron. You can go to my Facebook page listed below for close up pictures. If you bought everything this would cost you around $25 with a spare $10 tip.


To see more detailed photos Go to my Facebook Page:   / sixtyfivefordyoutubechannel8087584225...  

Mojolever Mojo Lever and No Mar make a similar bar if you want to buy one.