In this video, I design the wasteboard for the Onefinity CNC in Fusion 360.
The wasteboard design is super simple. I used 1/4 threaded Tnut inserts on the bottom side of the board so it's easy to clamp things down. After finishing the design I then used the Onefinity CNC to cut out the holes for the Tnut. The board is then flipped over, secured to the table, and level cut with a 1inch surfacing bit. This project should have been much easier but I managed to make numerous mistakes. Eventually, the wasteboard got completed and I am really to move on.
If you are looking for stepbystep instruction for setting up your Onefinity CNC. Here is a link to the factory setup guide. • Official Original Series Assembly Video
If you're interested in any of the aquariumrelated models please leave a comment and check out https://www.thingiverse.com/thing:470....
If you would like me to create something specifically for your nano reef aquarium, please join the conversation here...
https://www.reef2reef.com/threads/wha..., or leave a comment about what you would like me to make next.
Thanks, Mark