Pipeline sizing and hydraulic study are very important for an economical plant design.
In this video, you will learn how to calculate the pressure drop inside the pipe and use of adjust function. You will see how the adjust function provides help to determine the feed flowrate for having the limiting velocity in the pipeline. In the end, you will see the plots (pressure drop vs pipe length and many others).
If you find my content helpful, please don't forget to subscribe to my channel . If you want ❤ to learn Aspen HYSYS from very basic, then check the following links:
Tutorial # 1
Getting started with Aspen HYSYS
• Getting started with Aspen HYSYS
Tutorial # 2
Bubble point, Dew point and Phase diagram calculations
• Bubble Point, Dew Point, Phase Diagra...
Tutorial # 3
Flash calculations in HYSYS
• Flash Calculations in HYSYS
Tutorial # 4
Sensible and latent heat and generation of saturated steam table in Aspen HYSYS
• Sensible and latent heat and generat...
Tutorial # 5
Centrifugal pump sizing and selection in six easy steps
• Centrifugal pump sizing and selection...
Tutorial # 6
Pump power and efficiency calculations in HYSYS
• Pump power and efficiency calculation...
Tutorial # 7
Pump performance curves generation and rating in HYSYS
• Pump performance curves generation an...
Tutorial # 8
Simulation of Compressor and Turbine in Aspen HYSYS
• Simulation of Compressor and Turbine ...
Tutorial # 9
Compressor Surge Analysis in Aspen HYSYS
• Compressor Surge Analysis in Aspen H...
#Pipe pressure drop #Adjust function #Pipe sizing #Pressure drop profiles