Watch as compare different 3D printing material agains a 60in foam wing. My goal was to be within 50 grams of the entire RTF foam wing. Using ColorFabb LWPLA I made a ready to fly LWPLA wing that was 40 grams over. Challenge complete. I test flew all three of these wings also check it out. Thank you for watching.
Thank you so much for watching!
If you like videos like this, consider buying me a coffee, it really supports me: https://www.buymeacoffee.com/troymcmi...
See what else I am working on: / troymcmillan_rc
https://www.tiktok.com/@troymcmillan_...
#3Dprinted,#RCairplane, #ItFlies
ColorFabb LWPLA: https://colorfabb.com/lwplanatural
How to Build Foam Timber: • The Best Beginner DIY RC Airplane
Foam Timber Materials:
20x30 3/16" Waterproof Foam Board: https://amzn.to/3hnmyHn
Motor 2832 Brushless: https://amzn.to/3gl3bgL'>https://amzn.to/3gl3bgL
10x4.5 Propeller: https://amzn.to/2FRyAuX
Prop adapter: https://amzn.to/2YmXVmT
Esc 30amp: https://amzn.to/3gl3bgL'>https://amzn.to/3gl3bgL
6x 9g servos: https://amzn.to/31kj82B
Receiver ar620: https://amzn.to/3j4PbK4
YHarness: https://amzn.to/2YrYjAl
Assortment of 3Pin Extension Cables: https://amzn.to/3l1xNYt
3S 2200mha Batteries: https://amzn.to/3l6vCTf
Spektrum DX6 Controller: https://amzn.to/3l6NFsD
3D Printer: https://amzn.to/3hn5cdN
Flexible PLA: https://amzn.to/34mA4rd
You’ll also need: 2x 4.25in Wheels: https://amzn.to/3ldv5yT'>https://amzn.to/3ldv5yT
1.5 in tail wheel: https://amzn.to/3ldv5yT'>https://amzn.to/3ldv5yT
1mm Push Rod Wire: Purchase this at your local hardware or hobby store, I used solid steel "music" wire 2mm wire for landing gear: Same as above, hardware or hobby store
Disclaimer: I am sponsored by some of the products I mention. However, all of my opinions are my own. Some of the above links are affiliate links, that does not effect the price you pay for a product, but I may receive a small commission if you make a purchase. This helps support my channel and allows me to continue to make videos like this. Thank you for your support!