DIY Solar Products https://signaturesolar.com/?ref=ltgilfgo
WGen11500TFC Generator https://creatoriq.cc/4ghbgTV
Titanium Exhaust Tape / Wrap https://amzn.to/3MCiSmA
AntiVibration Pads https://amzn.to/3XxkO62
Spark Plugs (change the factory plug right away) https://amzn.to/4eb0r4g
Automatic 110v Transfer Switch https://amzn.to/3zqqDbJ
Exhaust Pipe & Flange / Stub https://amzn.to/4cQePOx
Shed https://amzn.to/3pUnVD8'>https://amzn.to/3pUnVD8
Exhaust Exit https://amzn.to/3zJ1PM8
MicroAir AC Soft Start Kit (Any AC Size) https://amzn.to/4dYkJhA
AIRGO AC Soft Start Kit (Check Amperage Requirements) https://amzn.to/4dT9LKg
Suncast Outdoor Shed https://amzn.to/3pUnVD8'>https://amzn.to/3pUnVD8
Fan https://amzn.to/3ADgHYv
Plug for Power to Panel https://amzn.to/3yIOeiv
Smart Energy Monitor for Panel https://amzn.to/4cQiwnB
More details on Neutral / Ground Bonding…
Having two points of neutraltoground bonding in an electrical system can cause several problems, including:
1. **Ground Loop Issues**: When there are multiple neutraltoground connections, it creates a loop. This can cause circulating currents through the ground wire, leading to ground loop currents that can cause interference in sensitive electronics, data errors, noise, and hum in audio equipment.
2. **Incorrect Current Path**: Ideally, current should flow through the neutral wire. With multiple bonding points, some of the current could flow through the grounding system (e.g., metal conduit, water pipes, or structural steel), which is unsafe and not designed to carry current under normal conditions. This can create a potential shock hazard if the ground path is compromised.
3. **Overloaded Grounding System**: The additional neutraltoground connection can cause the grounding system to carry a significant amount of current, potentially leading to overheating and damage to the grounding conductors, which are not sized for carrying normal circuit currents.
4. **Nuisance Tripping of Ground Fault Devices**: Devices like Ground Fault Circuit Interrupters (GFCIs) or Residual Current Devices (RCDs) may trip unnecessarily due to the stray currents resulting from the improper bonding.
5. **Violation of Electrical Code**: Most electrical codes, like the National Electrical Code (NEC) in the United States, specify that neutraltoground bonding should occur at only one point (usually at the main service panel). Multiple bonding points can lead to noncompliance with these standards.
To avoid these issues, neutral and ground should only be bonded at a single point in the electrical system, usually at the main service entrance panel.