The Jackrammer Kit is used to punch holes under pavement to install pipes and conduit easily with the Bullet Mole. Traditionally, the bullet mole is used with a sledgehammer for this purpose. The Jackrammer Kit eliminates the need to swing a sledgehammer and makes the job easier for one person.

The video demonstrates how to use the Jackrammer Kit to punch a 3in diameter hole under a 20ft wide driveway and install a 2in polyethylene gas line. In the first step, a trench needs to be dug which is approximately 14 inches wide and at least 10ft long. The depth of the trench should be 5 inches deeper than the penetration point. Then the Jackrammer needs to be prepared by sliding the Leverage assembly into the pockets on the inside wall of the Jackrammer. After that, the Jackhammer needs to be secured inside the Jackrammer and connected to the power source. The digging bar is then inserted into the digging bar sleeve and secured. The bullet mole needs to be assembled and placed into the trench. Once everything is set up, the Jackhammer switch can be turned on to punch a hole. The operator needs to push and pull the leverage bar forward as the bullet mole begins to penetrate the soil. After the hole is punched, pipes can be installed. The video also includes instructions on how to extract the shaft and install the pipe in the entrance trench.

Order the Jackrammer Kit here: https://bulletmole.com/products/jack...