*SEE TABLE OF CONTENTS BELOW*

As this is a long and intense video, feel free to skip ahead to a specific section of the video. Also be aware there is a PART 2 of this process.

Steve walks us through the process of rebuilding a P125 motor. This will be the same or very similar on most vintage large frame Vespas with some minor exceptions. In addition to inspecting all aspects of the motor during tear down, Steve points out all the wear items that should usually be replaced during a rebuild. We also went ahead and installed a Malossi cylinder kit and upgear kit while we were at it.

TABLE OF CONTENTS:
Prepping Frame 1:04
Drain Oil/Remove Fan Shroud 1:40
Remove Selector Box 3:15
Remove Cylinder 17:49
Split Crankcase 25:05
Gear Removal 32:25
Shifting Cross 35:36
Engine Removal 38:08
Rear Hub/Brakes 39:03
Clutch 42:41
Remove Crankshaft 46:07
Axle/Lay Shaft/Main Seal 46:57

VESPA MOTORSPORT
3955 Pacific Hwy.
San Diego, CA 92110

For the largest selection of parts and accessories in North America, please visit our website:
WWW.SCOOTERWEST.COM

Thanks for viewing!