If having difficulty getting off the CV axle nut or lug nut on your car, then this simple procedure will do it! This was performed on a Chrysler 300, but the process is the same for any other vehicle. Click SHOW MORE to see details & tools used. If this video helped please SUBSCRIBE AND LIKE. CLICK SHOW MORE



to help support and grow this channel you can also send me a cup of coffee ☕ here:

https://www.buymeacoffee.com/randomca...
OR
https://kofi.com/fixcaryourself
OR
➡ Click the SUPER THANKS button above.



This video shows how to remove a spinning Axle Nut IF the car is already raised or lifted up by a floor jack or bottle jack:    • Remove Stuck  Spinning CV Axle Nut ...  

AND

This video shows how to identify all the symptoms of a bad CV Axle Half Shaft
   •  How To Know If CV Axle Half Shaft I...  



Supplies you need:

1) Automatic Transmission Fluid (ATF) https://amzn.to/324RzKS

2) Acetone https://amzn.to/3oMVFRm

3) Paper Cup

4) Toothbrush

5) Steel wool, brush, shop towels or cloth: https://amzn.to/34NvRfQ

6) Breaker bar 1/2": https://amzn.to/3oQGTJx

7) Socket (in this video 32 mm was used): https://amzn.to/2HWyzHp

8) Torque Wrench 1/2 " or Torque power gun: https://amzn.to/3eiZl8P


9)

If you think you need a new CV Axle nut, they usually come with a new cv axle, however you can also purchase them separately if a must.


Here is the link for a new CV Axle Nut https://amzn.to/3n2VH72





INSTRUCTIONS :

Soak the axle nut preferably overnight with a half mixture of Automatic Transmission fluid also known as ATF and Acetone. Place a soaked steel wool, napkin or cloth on the axle nut, and place the wheel cover cap back on if possible.


Next grab a 32 mm socket (or your acceptable socket for your vehicle) and breaker bar and start loosening it. If it doesn't feel loose, you can apply another coat and/or heat it up with a torch to help break loose the rust.


Once the axle nut is off make sure the nut and its threads are still in great condition. If not then replace the axle nut with a new one (see supplies above), otherwise screw it back on the axle end by hand at first.


Then use a socket with a ratchet wrench to tighten it.


Finish torqueing it to 157 ft. lbs or whatever the manufacture states for your vehicles axle nut.




Hope this video guide helped and that you save money and do this simple under 30 minute job yourself.




PLEASE SUBSCRIBE &

Thanks.