Spektrum DX9 programing for beginners,
Here a Glider 4 flap wing setup, with 3 flt. modes
A good start setup is:
Flt mode
thermal: flaps 2 mm aileron 1 mm down
Cruise: neutral flaps and aileron
Speed: flaps and aileron 1,5 mm up.
Snapflaps, (elevator to flaps):
Full up elevator: 2mm down flaps 1 mm down aileron
Aileron to flaps: Around the half flaps th
Full down elevator: 3 mm up flaps 1,5 mm up aileron
Flaps to elevator, full flaps 2 mm down elevator.
Program DX G2
1. Select plane type: Chose always glider if you want to use spoilerons or flaps
2. Select wing type. Also motor if it’s a motor plane or motor glider. If it is a flying wing then use motor plane.
3. Set trim set up to F mode
4. Activate F mode. 1, 2, 3, maybe more if you want to use more than 3 flight modes on a glider
5. Put in the servo plugs in the receiver, it can change for the wing type.. Use the monitor to see this….
6. Set the right directions and sub trim the servos.
7. Set the travel for the servos
8. Set the ailerons differential, not too much because this can be a problem when using spoilerons and flaps
9. Dual rate and expo, 50% on ailerons and 40% on elevator and rudder is a good start.
10. Camber preset: Motor plane/Glider, here you adjust: Motor plane: Flaps up/ take off flaps/ landing flaps and elevator compensation and how fast the flaps move. Glider:Flight modes as Thermal /cruise/speed and how fast it changes
11. Camber system: Glider, here you adjust landing flaps/ crow brake and which switch or stick you will use for it. (In crow brake not more up aileron when using the crowbrake that when using the ailerons the aileron that going down must go down to neutral, in this way you still have good aileron control.
12. MIX: Flaps elevator, here you adjust the elevator compensation when using the landing flaps (Camber system) and adjust the offset so that the elevator start moving when the flaps is moving when using the throttle stick to control it. 2 mm down when using the flaps is a good starting point.
13. Mix: Ailerons flaps, here you adjust all span ailerons
14. Elevator flaps, here you adjust the Aileron –rudder, here you adjust snap flaps
15. Aileron –rudder, here you adjust as described
16. Set up the spoken Flight modes and switch change sounds
17. Set up telemetry in auto config.
18. Motor planes with flaps: you can go to elevator dual rate and set the switch to fl mode/ flaps switch and then set it so you still have full up elevator movement, when using the flaps and have set down elevator compensation, in this way you still have enough up elevator to pull up in the landing when using the flaps
19. Set the timer

If you program a flying wing with 4 flap wing, then set it up as a glider with 2 ailerons and V tail. Outer flaps are ailerons and inner flaps is the elevator/rudder
Then a mix: Aileron rudder to 100 % and elevator L aileron 100%
And then set the Dual rate for the rudder to %
Good luck