It's no secret that I wrench... A LOT! In the past year especially, my business constructing large multirotors has allowed me the pleasure of building dozens of large drones, each comprised of a few hundred bolts each. This leads to lots and lots of wrench turning.

I've always been one to prefer a good ole fashioned hex driver hand tool, as I can control the speed quite easily, feel increased resistance to prevent crossthreading, and after 15 years of wrenching, let's just say my hand torque is well dialed in to knowing how tight is appropriate but won't break a bolt. It does take a bit longer but has always done the job for me.

So... when I came across this tool recently, I was so impressed that I had to share! I have been using this on all of my builds in the last few months and it is really holding up nicely and increasing my workflow.

Here is a completely unbiased review of the DeWalt DCF680 Cordless Screwdriver. Hope this can help you with your wrenching!

BEST FEATURES:

Gyroscopic enabled!!
Built in clutch
Swappable Batteries (2 included with the combo!)
Bright LED on the front
Standard 1/4" Hex Receiver
Folds from straight to a right angle driver
Light weight

If you turn wrenches for your hobby or job, I highly recommend this! Would be perfect for RC helicopters, drones, cars, boats you name it.

I bought it here on Amazon:

https://amzn.to/2uYMB4w

In addition, these bits from MIP are great! It's a set of 1.5mm, 2.0mm and 2,5mm hex wrenches (perfect for metric smaller screws):

https://amzn.to/38hB3Yy

Special thanks to my boy Chris Baquol from Air Imaging Solutions for the video!