Welcome to LeeMerie3D! In response to overwhelming demand, I'm thrilled to present this highly requested video on tuning 3D printers. Many of you have asked about my process for achieving optimal machine performance, and in this video, I'm sharing the exact steps I take after completing a build.

By following these steps meticulously, you'll be on your way to achieving flawless prints just like mine! Whether you're a seasoned enthusiast or a beginner, this comprehensive guide is designed to help you finetune your machines for exceptional results.

Don't hesitate to reach out if you encounter any challenges along the way! Join our vibrant community on Discord (linked below) where fellow makers share insights, troubleshoot, and inspire one another.

Good luck, and may this guide empower you to unlock the full potential of your 3D printer! Remember, precision and patience are key to mastering this craft.

Join our Discord community for support:   / discord  


00:00 Intro
00:50 Esteps Calibration Energize Stepper
01:06 Esteps Calibration Measuring Filament 100mm
02:08 Esteps Calibration Extruding 100mm
02:40 Esteps Calibration Measure Offset Distance
02:56 Esteps Calibration Calculate Rotation Distance
04:10 Esteps Calibration Second Measurement Verify
05:02 PID Tuning Heater Bed
06:46 PID Tuning Hot End
08:47 Pressure Advance Intro
09:10 Pressure Advance Ellis Calibration Tool
12:11 Pressure Advance Printing Gcode File
12:42 Pressure Advance Inspect and Get PA Values From Print
13:25 Extrusion Multiplier Ellis Tuning Guide
14:05 Extrusion Multiplier Setting Proper Slicer Settings (SS)
16:00 Extrusion Multiplier Printing Cubes
16:05 Extrusion Multiplier Inspect Printed Cubes And Identify Flow Rate (Per Filament Brand)
18:09 Input Shaper Intro
19:04 Input Shaper Pre Flight Checklist
19:36 Input Shaper Klippian Shake & Tune
20:55 Input Shaper Execute Commands
21:40 Input Shaper Inspect Graphs
22:21 Input Shaper Change Printer.cfg Input Shaper Values
23:07 Outro


Need help with your first layer? Watch this video!
   • Stop The Warping!  


Esteps Docs
https://docs.vorondesign.com/build/st...


PID Tuning Docs
https://docs.vorondesign.com/build/st...


Cheat Sheet of PID Commands Used

PID_CALIBRATE HEATER=heater_bed TARGET=110
PID_CALIBRATE HEATER=extruder TARGET=255


Ellis Pressure Advance Calibration Tool
https://ellis3dp.com/Pressure_Linear_...


Ellis Extrusion Multiplier Guide
https://ellis3dp.com/PrintTuningGui...


Download these cubes to use (Or create your own)
https://github.com/AndrewEllis93/Prin...


Link to better images by Ellis for Extrusion Multiplier
https://ellis3dp.com/PrintTuningGui...


KLIPPER Measuring Resonance
https://www.klipper3d.org/Measuring_R...


Klippian Shake & Tune (HIGHLY RECCOMMENDED)
https://github.com/Frixx/klippainsh...


Royalty Free Music from Tunetank.com
Track: Get Up by VensAdams
https://tunetank.com/track/3775getup/

Royalty Free Music from Tunetank.com
Track: Sunny Memories by Dima Tyshko
https://tunetank.com/track/1587sunny...

#3d #3dprinting #voron #clipper #inputshaper #esteps #tuning