Flow coefficient (Cv) is defined as the number of gallons per minute (gpm) at 60°F that will pass through a full open valve with a pressure drop of 1 psi.
Valve Flow Coefficient (Cv) is a valve’s capacity for a liquid or gas to flow through it. It is technically defined as “the volume of water at 60°F (in US gallons) that will flow through a valve per minute with a pressure drop of 1 psi across the valve.”
When selecting valves, choose the closest to the calculated Cv, typically rounding down unless a specified maximum ΔP of a project is exceeded. An oversized valve may cause control issues such as hunting or poor heat transfer (delta T) across a coil due to overflow. Conversely, an undersized valve may not provide enough flow and exceed available ΔP.
The relationship between pressure drop and flow rate through a valve is conveniently expressed by a flow coefficient (Cv)
Cavitation in control valve : In a control valve, if the liquid's pressure falls below its fluid vapor pressure, vapor bubbles will form and these bubbles burst after the pressure is increased beyond the vapor pressure curve is called cavitation in control valve
Flashing and cavitation in control valves : In a control valve, if the liquid's pressure falls below its fluid vapor pressure, and if the downstream pressure remains below the vapor pressure of the fluid, the process condition is called flashing.
Choked flow control valve : Choked flow is the point at which decreasing downstream pressure will not increase the flow through a valve. At this point the velocities are the highest and cavitation at this stage is very severe.
#cavitationindexincontrolvalve #sigmacalculationincontrolvalve #controlvalvecavitationindexcalculation #Control Valves #Controlvalves #cavitation #flashing #chockedflow #cavitationincontrolvalve #flashingandcavitationincontrolvalve #chockedflowcontrolvalve #realpars #instrumentation #valves #instrumentationinterviewquestionandanswers
FREE EBook on Engineering PIP Standards
https://www.asadshaikh.com/newslette...
( ) Link to FREE Udemy Course for I&C Professionals
1500+ Engineers have taken the Course
(Engineers have said it is even BETTER than the PAID Courses available)
Give it a Try
https://asadshaikhinstrumentation.c...